HP V1910 Switch Series - Page 378

Figure 334 Network diagram for RADIUS server configuration
Configuration procedure
NOTE:
Enable the Telnet server function, and configure the switch to use AAA for authentication, authorization
and accounting of Telnet users.Detailed configuration steps are omitted here.
1. Configure IP addresses for the interfaces. Detailed configuration steps are omitted here.
2. Configure RADIUS scheme system
# Configure the RADIUS authentication server.
 From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration page
appears.
Figure 335 Configure the RADIUS authentication server
 Select Authentication Server as the server type.
 Enter 10.110.91.146 as the IP address of the primary authentication server
 Enter 1812 as the UDP port of the primary authentication server.
 Select active as the primary server status.
 Click Apply.
# Configure the RADIUS accounting server.