Huawei ECC800-Pro - Page 28

Item Specications
Fault isolation There are three groups of 12 V ports. A group has a maximum
current of 660 mA, a route has a maximum current of 800 mA,
and the maximum total current is 2 A.
Group 1: 12 V of the AIDI_1 and DO/12V ports
Group 2: 12 V of the AIDI_2, COM1/AIDI_4, and COM3/12V
ports
Group 3: 12 V of the AIDI_3 and COM2/AIDI_5 ports
Wireless
communicatio
n
Supports wireless communication that complies with
IEEE802.15.4.
4G Supports the 4G module, SMS sending, and 3G communication,
and provides a standard SIM card slot.
1. China: 2G and 4G networks support China Unicom or China
Mobile SIM cards, and 3G networks support only China
Unicom SIM cards.
2. Outside China: Select SIM cards according to the following
wireless modes and frequency bands:
● 4G: wireless mode (FDD-LTE and TDD-LTE), coverage
frequency band (B1, B3, B5, B7, B8, and B20)
● 3G: wireless mode (WCDMA), coverage frequency bands
(B38, B40, and B41)
● 2G: wireless mode (GSM), coverage frequency band
(900/1800 MHz)
NOTE
● The prerequisite for using a SIM card is that the site has signal
coverage.
● Due to the performance limitation of the wireless module, China
Telecom SIM cards are not supported.
USB ● Supports USB 2.0 and 5 V, 1 A power supply.
● After installing the WiFi module, connect the WiFi module
to the ECC800-Pro using the app on the mobile phone or
tablet computer to view the basic information about the
smart module, such as layout, resources, energy eciency,
environment, and alarms.
● You can insert a USB ash drive to export historical data
and conguration les and import conguration les.
SW button ● Restores the default IP address, factory settings, and user
information.
● Supports RF_Z networking.
ECC800 Data Center Controller
User Manual (for ECC800-Pro) 3 Device Description
Issue 02 (2020-09-07) Copyright © Huawei Technologies Co., Ltd. 17