G1E Programming Manual
193
Programming Single Digit DISA
Single Digit DISA uses all the same programming modes plus the following
Set mode 05-11-08 to enable single digit DISA and select which time periods single Digit DISA will be activated
(Day/Night etc)
Single digit dialling destinations in the G2 system are to Hunt Groups 1 to 8 corresponding to digits 1 to 8 dialled
by the caller. If the option of dialling stations direct is needed then the Hunt Group corresponding to the leading
digit of the system numbering plan must have the corresponding Hunt Group number pilot number left blank and
then dialling that digit can proceed to dial a full extension number. For example if the system numbering scheme
is all stations numbered 500-600 then Hunt Group number 5 must be left unprogrammed.
To program Hunt Group Pilot numbers and members see the Help File for Pilot Groups.
Mode 05-16-03 adds the option of a second level message where incoming callers are given a standard
greeting message with the option of dialling a single digit and going to a second greeting message with the
single digit dialling options.
To Next Page
Loading...
