4-65
SECTION 4
OPERATION
Set Level attenuation as follows:
X1
Selects X1 (times 1) level attenuation.
/10
Selects /10 (divide by 10) level attenuation.
T
e
n
Level selections range from 0 to 2.5 Vp in X1 (times 1) mode and 0 to
25.0 mVp in /10 (divide by 10) mode.
Select Mode as follows:
CONT
Selects continuous transmission of a
signal.
BURST
Executes a single transmission of
selected signal.
T
e
n
If TONE is selected as Format, enter duration time for TONE Burst in
T= field. Time duration ranges from 0 to 30 seconds.
CONTMode :
Level : 0.00 Vp
CONTMode :
Level : 0.00 Vp
To Next Page
Loading...
General