6-51
SECTION 6
OPTIONS
6. Power Lev Tolerance
Selects tolerance used for Power Level Test. Consists of two editable fields:
Positive Tolerance and Negative Tolerance. Range for both fields is from 0% to
99% or 0 to 99 dB. For each field, select using DATA ENTRY Keys. Press
ENTER Key to complete edit.
7. RF
Freq Err Tolerance
Selects tolerance for RF Frequency Error measurements. Range is 0.00 to
9.99 kHz. Select using DATA ENTRY Keys. Press ENTER Key to complete edit.
8. SAT
Freq Tolerance
Selects tolerance for SAT Frequency measurements. Range is 0 to 99 Hz. Select
using DATA ENTRY Keys. Press ENTER Key to complete edit.
9. ST
Freq Tolerance
Selects tolerance for Signal Tone (ST) Frequency Test. Range is 0 to 999 Hz.
Select using DATA ENTRY Keys. Press ENTER Key to complete edit.
10. SAT
Dev Tolerance
Selects tolerance for SAT Deviation measurements. Range is 0% to 99%. Select
using DATA ENTRY Keys. Press ENTER Key to complete edit.
11. ST
Dev Tolerance
Selects the tolerance used to determine if the Signal Tone (ST) Deviation Test
passes or fails. Range is from 0% to 99%. To set, move cursor to “11. ST Dev
Tolerance” and press ENTER Key. Use DATA ENTRY Keypad (29) to enter a
tolerance and press ENTER Key.
12. Flash
Dur Tolerance
Selects the tolerance used to determine if the Flash Hook Duration Test passes or
fails. Range is from 0% to 99%. To set, move cursor to “12. Flash Dur
Tolerance” and press ENTER Key. Use DATA ENTRY Keypad (29) to enter a
tolerance and press ENTER Key.
To Next Page
Loading...