IFR COM-120C

6-54
SECTION 6
OPTIONS
9. DTMF
Displays DTMF digits transmitted after “ENTER DIGITS” prompt.
10. Flash
Dur
Displays Flash Hook signal time duration transmitted by Mobile Phone under test.
11. ST
Freq
Displays Signal Tone frequency transmitted by Mobile Phone under test.
12. Hangup
Dev
Displays deviation of hang up signal of Mobile Phone under test.
13. TX
Pwr
Displays Mobile Phone Output Power. Mobile Phone is set to Power Level
Reference in AMPS Setup Menu.
14. SAT
Dev
Displays deviation of SAT transmitted by Mobile Phone under test.
15. Freq Err
Displays error of Reverse Voice Channel Frequency received from Mobile Phone.
16. SAT
Freq
Displays SAT frequency transmitted by Mobile Phone under test.
17. Called
Adr
Displays phone number transmitted by Mobile Phone under test.
The Power Level Test sends the VMAC values 0 to 7 to the Mobile Phone and the
output power is measured.
18. Level
Displays power levels of Mobile Phone.
19. Reading
Displays power readings of Mobile Phone for each power level.