CABLE STATEMENT
Double shielded and properly terminated external interface cables must be used with this
equipment when interfacing with the RS-232 and IEEE-488.
For continued EMC compliance, all external cables must be 3 meters or less in length.
NOMENCLATURE STATEMENT
The COM-120C Communications Service Monitor is the official nomenclature for the EMC and
Safety compliant COM-120C Communications Service Monitor. In this manual the COM-120C
refers to the COM-120C Communications Service Monitor. The generic terms unit and Test
Set also refer to the COM-120C Communications Service Monitor.
BATTERY STATEMENT
For continued EMC compliance with EN61000-3-2:1995/A14:2000, always allow a discharged
battery to recharge in Stand-by Mode.
To Next Page
Loading...