SAFETY FIRST: TO ALL OPERATIONS PERSONNEL
REFER ALL SERVICING OF UNIT TO QUALIFIED TECHNICAL PERSONNEL. THIS UNIT CONTAINS NO
OPERATOR SERVICEABLE PARTS.
CASE, COVER OR PANEL REMOVAL
Removing protective covers, casings or panels from this unit exposes the operator to electrical hazards that
can result in electrical shock or equipment damage. Do not operate this unit with the case, cover or panels
removed.
SAFETY IDENTIFICATION IN TECHNICAL MANUAL
This manual uses the following terms to draw attention to possible safety hazards, that may exist when
operating or servicing this equipment.
CAUTION: THIS TERM IDENTIFIES CONDITIONS OR ACTIVITIES THAT, IF IGNORED, CAN RESULT IN
EQUIPMENT OR PROPERTY DAMAGE (E.G., FIRE).
WARNING: THIS TERM IDENTIFIES CONDITIONS OR ACTIVITIES THAT, IF IGNORED, CAN RESULT IN
PERSONAL INJURY OR DEATH.
SAFETY SYMBOLS IN MANUALS AND ON UNITS
CAUTION: Refer to accompanying documents.
AC OR DC TERMINAL: Terminal that may supply or be supplied with ac or dc voltage.
DC TERMINAL: Terminal that may supply or be supplied with dc voltage.
AC TERMINAL: Terminal that may supply or be supplied with ac or alternating voltage.
SWITCH OFF: AC line power to the device is OFF.
SWITCH ON: AC line power to the device is ON.
DANGEROUS VOLTAGE: Indicates electrical shock hazard due to high voltage levels.
CAT II
INSTALLATION CATEGORY II: Denotes impulse withstand voltage of 2500 V.
EQUIPMENT GROUNDING PRECAUTION
Improper grounding of equipment can result in electrical shock.
USE OF PROBES
Check the specifications for the maximum voltage, current and power ratings of any connector on the unit
before connecting it with a probe from a terminal device. Be sure the terminal device performs within these
specifications before using it for measurement, to prevent electrical shock or damage to the equipment.
AC POWER CORD
AC power cord must not be frayed or broken nor expose bare wiring when operating this equipment.
DC POWER CORD
DC power cord is non-terminated. Care should be taken when connecting to external dc source.
USE RECOMMENDED FUSES ONLY
Use only fuses specifically recommended for the equipment at the specified current and voltage ratings.
INTERNAL BATTERY
This unit contains a Sealed Lead-Acid Battery, see Battery Instructions for servicing.
To Next Page
Loading...
General