Intel Stratix 10

•
fw_default
• all legal values
5. Initial Adaptation and continuous adaptation parameter adaptable options are:
• fix
• adaptable
Some parameters are adaptable in order to compensate for loss. They may also be
fixed which means that the parameter does not adapt when initial adaptation or
continuous adaptation runs.
6.
If one of the parameter minimum or maximum values is fw_default, all three
minimum or maximum values, respectively, need to be fw_default.
Figure 94. GUI for Continuous Adaptation PMA Configuration Setup
1. Continuous Adaptation parameter adaptable: options are fix and adaptable
2. Continuous Adaptation parameter values: options are
same_as_initial_parameter and all legal values
Multi-PMA-Configuration Support
One native PHY supports up to eight different PMA configurations. You can choose one
PMA configuration and load it for editing. The table shows the settings in each PMA
configuration, which provides an overview of all PMA configurations.
PMA Adaptation settings can be further tuned for any channel. Refer to PMA Registers
0x200 to 0x203 Usage.
You can select the soft registers to choose and load the test configuration. The status
of the test configuration load feature can be monitored using rcp_load_finish.
8. Dynamic Reconfiguration Examples
UG-20056 | 2019.02.04
Intel
®
Stratix
®
10 E-Tile Transceiver PHY User Guide
Send Feedback
160