Juniper SRX5400 - Page 314

Password:
root@node0%
b. Before you mount the USB flash drive, list all the directories with names starting with da in the dev
folder:
root@node0% ls /dev/da*
root@node0% ls /dev/da*
/dev/da0 /dev/da0s1c /dev/da0s2a /dev/da0s3 /dev/da0s3e
/dev/da0s1 /dev/da0s1f /dev/da0s2c /dev/da0s3c
/dev/da0s1a /dev/da0s2 /dev/da0s2f /dev/da0s3d
c. Insert the USB flash drive in the USB port.
The following output is displayed:
root@node0% umass1: TOSHIBA TransMemory, rev 2.00/1.00, addr 3
da2 at umass-sim1 bus 1 target 0 lun 0
da2: <TOSHIBA TransMemory 5.00> Removable Direct Access SCSI-0 device
da2: 40.000MB/s transfers
da2: 983MB (2013184 512 byte sectors: 64H 32S/T 983C)
d. List all the directories with names starting with da in the dev folder, and identify the USB drive.
root@node0% ls /dev/da*
root@node0% ls /dev/da*
/dev/da0 /dev/da0s1c /dev/da0s2a /dev/da0s3 /dev/da0s3e
/dev/da0s1 /dev/da0s1f /dev/da0s2c /dev/da0s3c /dev/da2
/dev/da0s1a /dev/da0s2 /dev/da0s2f /dev/da0s3d /dev/da2s1
In this example, the USB flash drive is /dev/da2s1.
e. Create a directory to mount the USB flash drive:
root@node0% mkdir /var/tmp/usb
f. Mount the USB flash drive to the /var/tmp/usb directory:
root@node0% mount -t msdosfs /dev/da2s1 /var/tmp/usb
g. Save the configuration on node 0 to the tmp folder:
317