Keithley 2280 Series - Page 108

Series 2280 Precision DC Power Supply Reference Manual Section 2: General operation
077085503 / March 2019 2-89
Math and statistics reset values
Setting*
Default value reset from
MENU > System >
Settings > Reset
Default value reset by the
*RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
MENU > Measure > Math > Type
:CALCulate[1]:<function>:FORMat (on page
7-21)
mx+b
MXB
MENU > Measure > Math > b (Offset)
:CALCulate[1]:<function>:KMATh:MBFactor
(on page 7-22)
+0.000e+0
0.0
MENU > Measure > Math > m (Gain)
:CALCulate[1]:<function>:KMATh:MMFactor
(on page 7-23)
+1.000e+0
+1.000000e+00
MENU > Measure > Math > Units
:CALCulate[1]:<function>:KMATh:MUNits
(on page 7-25)
X
"X"
MENU > Measure > Math > State
:CALCulate[1]:<function>:STATe (on page
7-26)
Off
0 (Off)
MENU > Measure > Data Buffers >
Statistics Format
:CALCulate2:FORMat:ELEMents (on page
7-30)
All
"READ, UNIT"
MENU > Measure > Data Buffers >
Statistics Function
:CALCulate2:FUNCtion (on page 7-31)
Current
CURR
MENU > Measure > Data Buffers >
Statistics
:CALCulate2:FORMat (on page 7-28)
Minimum On
Maximum On
Peak-Peak On
Mean On
Std Dev On
MIN, MAX, MEAN,
SDEV, PKPK
MENU > Measure > Data Buffers > Size
:TRACe[n]:POINts or :DATA[n]:POINts (on
page 7-142)
100
100
MENU > Measure > Data Buffers >
Autoclear
:TRACe[n]:CLEar:AUTO or
:DATA[n]:CLEar:AUTO (on page 7-135)
On
1 (On)
MENU > Measure > Data Buffers > Mode
:TRACe[n]:FEED:CONTrol or
:DATA[n]:FEED:CONTrol (on page 7-141)
Always
ALW (Always)
MENU > Views > Sheet > Statistics
:CALCulate2:STATe (on page 7-34)
Off
0 (Off)
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed
here on the menu, it may not be available for the function you are using.