Keithley 2280 Series - Page 114

Series 2280 Precision DC Power Supply Reference Manual Section 2: General operation
077085503 / March 2019 2-95
Trigger reset values
Setting*
Default value reset from
MENU > System > Settings >
Reset
Default value reset by the
*RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
MENU > Trigger Configure > Idle
:INITiate[n]:CONTinuous (on page 7-51)
Cont:Off
0 (Off)
MENU > Trigger Configure > Arm Count
:ARM[:SEQuence[n]]:COUNt (on page 7-19)
1
1
MENU > Trigger Configure > Arm Source
:ARM[:SEQuence[n]]:SOURce (on page 7-20)
Immediate
IMM
MENU > Trigger Configure > Trigger Count
:TRIGger[:SEQuence[n]]:COUNt (on page 7-
149)
1
1
MENU > Trigger Configure > Trigger Source
:TRIGger[:SEQuence[n]]:SOURce (on page 7-
151)
Immediate
IMM
MENU > Trigger Configure > Sample Count
:TRIGger[:SEQuence[n]]:SAMPle:COUNt (on
page 7-150)
1
1
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed here
on the menu, it may not be available for the function you are using.
Buffer reset values
Setting*
Default value reset from
MENU > System > Settings >
Reset
Default value reset by the
*RST (on page 7-7)
command or
:SYSTem:PRESet (on
page 7-124) command
MENU > Trigger > Configure > Idle
:TRACe[n]:CLEar:AUTO or
:DATA[n]:CLEar:AUTO (on page 7-135)
Cont:On
Cont:Off
MENU > Trigger > Configure > Arm Count
:TRACe[n]:POINts or :DATA[n]:POINts (on
page 7-142)
1
100
MENU > Trigger > Configure > Arm Source
:TRACe[n]:FEED or :DATA[n]:FEED (on page
7-140)
Immediate
SENS
MENU > Trigger > Configure > Trigger Count
:TRACe[n]:FEED:CONTrol or
:DATA[n]:FEED:CONTrol (on page 7-141)
1
ALW
* Some of the options listed in this table are only available for specific functions. If you do not see the option listed here
on the menu, it may not be available for the function you are using.