Keithley 2651A

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 6: Instrument programming
2651A-901-01 Rev. A / March 2011 6-9
NOTE
To retrieve the commands in the anonymous script, use script.anonymous.list().
Example: Retrieve source code one line at a time
test7.list()
Retrieve the source of a script named
"test7".
Retrieve a script as a single string
To retrieve the entire user script source code as a single string, use the scriptVar.source
attribute. The loadscript or loadandrunscript and endscript keywords are not included.
To retrieve the source code as a single string, send the command:
print(scriptVar.source)
Where scriptVar is the name of the script.
Example: Retrieve the source code as a single string
print(test1.source)
Retrieve the source of a script named
"test1".
Retrieve a script using TSB Embedded
In TSB Embedded, from the User Scripts list, select the script you want to retrieve. The contents of
the script are displayed. See Working with TSB Embedded
(on page 6-37) for more information.
Script example: Retrieve the content of scripts
This set of examples:
• Retrieves the source of a script using scriptVar.source
• Retrieves the source of a script using scriptVar.list()
Example: Retrieve the content of a script with scriptVar.source
print(scriptVarTest.source)
Request a listing of the source of
scriptVarTest. The instrument outputs the
following (note that the loadscript and endscript
commands are not included).
Output:
listTones = {100, 400, 800}
for index in listTones do
beeper.beep(.5, listTones[index])
end