240 Keysight InfiniiVision HD3-Series Oscilloscopes User's Guide
18 Fault Hunter
4 Select Auto Setup.
This will add a set of measurements on the signal that are used to determine
the measurement limits. For more about this process, see
"More About Fault
Hunter Auto Setup"
on page 242.
When Fault Hunter is done setting up the measurement limits, you will see limit
values populated in the test table.
If the signal under test changes, select Auto Setup again to re-calculate the
measurement limits.
Note that you can manually adjust the determined limits.
Auto Setup is the most important step in using Fault Hunter.
To Next Page
Loading...
