358
a: Polarity, b: Threshold, b: Offset, c: Attack, d: Release
The “Offset” parameter specifies the value for the “Control Tar-
get” parameter (that is set to None), expressed as the ratio rela-
tive to the parameter value (the “Wet/Dry” value with “Control
Target”=Out, or the “Feedback” value with “Control Tar-
get”=FB).
When “Polarity” is positive, the “Control Target” value is
obtained by multiplying the parameter value by the “Offset”
value (if the input level is below the threshold), or equals the
parameter value if the input level exceeds the threshold.
When “Polarity” is negative, Control Target value equals the
parameter value if the input level is below the threshold, or is
obtained by multiplying the parameter value by the “Offset”
value if the level exceeds the threshold.
The “Attack” and “Release” parameters specify attack time and
release time of delay level control.
048: Autopan Delay
This stereo delay effect pans the delay sound left and right using
the LFO.
Dynamic Delay
Threshold
Dry
Envelope
Wet
Control Target=Out
Polarity= (–)
Wet
Control Target=Out
Polarity= (+)
Delay Time
Time
(Ducking Delay)
Release
Attack
Level
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO Phase
LFO Shape
Pan
Pan
LFO: Tri / Sin
Depth
Delay
Delay
High Damp Low Damp
High Damp
Low Damp
Feedback
a
L Delay Time [msec]
Sets the delay time for the left channel
0.0...680.0msec
L Feedback
Sets the feedback amount for the left channel
–100...+100
b
R Delay Time [msec]
Sets the delay time for the right channel
0.0...680.0msec
R Feedback
Sets the feedback amount for the right channel
–100...+100
c
High Damp [%]
Sets the damping amount in the high range
0...100%
☞ Fx:043
Low Damp [%]
Sets the damping amount in the low range
0...100%
☞ Fx:043
d
LFO Waveform
Selects LFO Waveform
Triangle, Sine
LFO Shape –100...+100
Determines how much the LFO waveform is changed
☞ Fx:020
e
LFO Phase [degree] –180...+180
Sets the LFO phase difference between the left and right
☞ Fx:034
f
Panning Frequency [Hz]
Sets the panning speed
0.02...20.00Hz
g
Panning Depth
Sets the panning width
0...100
Src Off...Tempo
Selects the modulation source for the panning width
Amt
Set the modulation amount of the panning width
–100...+100
h
Wet/Dry Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 330
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 330
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 330
–100...+100
To Next Page
Loading...
Need help?
General
