KRONE ISOBUS-Terminal CCI 100
129
Appears briefly after a knot is tied; if activated (see chapter menu 1-2 “Knotter
Signal “), an audio signal is heard (horn sound for about 1 sec).
Operating hours counter (counts only when PTO is running)
Pos: 22.209 /BA/Inf o-Center/CCI-I SOBUS-Terminal/Menü 9 ISO-Ei nstellungen/Menü 9- 3 Hauptfenster konfigur ieren: Vorgehens weise @ 144\mod_13594723 70928_78.docx @ 1294588 @ 3 @ 1
Configuring Main Window:
• Call up the page to be configured by pressing function key
or
• By pressing function key
or , move the rectangle (1) into the desired row (1-7)
• Select the desired selection element via function key
or , the new display element
appears in the display and the symbol
in the upper line goes out
• Press function key
, the display symbol is saved, the symbol in the upper line
appears
• Pressing the function key
closes the called up menu
• Pressing the function key
and holding it down brings up the basic screen
Bringing up the Factory Setting:
• The factory setting is called up and saved by pressing and holding the function key
(for approx. 2 seconds)
Pos: 22.210 /BA/-- ------------- Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
