Krone Big Pack 4x4 - Adjusting the spring of the zeroizing device

Settings
229
Pos: 34.81.12 /Übersc hriften/Überschr iften 3/F-J/Feder des Nullstellers einstel len @ 107\mod_13342251128 47_78.docx @ 964800 @ 3 @ 1
11.11.3 Adjusting the spring of the zeroizing device
Pos: 34.81.13 /BA/Ei nstellungen/Großpac kenpresse/Variab les Füllsystem VFS/Bi G PACK 4x4/Nullsteller Feder Bild @ 107\mod_1334225 165147_78.docx @ 964828 @ @ 1
Fig. 168
Pos: 34.81.14 /BA/Ei nstellungen/Großpac kenpresse/Variab les Füllsystem VFS/Bi G PACK 4x4/Nullsteller Feder Text @ 107\mod_13342 25201961_78.docx @ 964 856 @ @ 1
The spring (15) is adjusted in the zero position (see Settings section “Zero position”).
The spring has been set to A = 185 mm at the factory.
Check and, if required, adjust dimension A:
• Pretension the spring (15) to a dimension of "A" = 185 mm
Pos: 34.81.15 /BA/---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1