Krone Big Pack 4x4 - Differing functions to KRONE ISOBUS terminal CCI

ISOBUS operation
140
Pos: 26.7 /BA/Inf o-Center/Iso-Bedi enung/BigPack/Abweic hende Funktionen zum KRONE I SOBUS-Termina CCI @ 47\ mod_1285223499328_78.d ocx @ 455993 @ 3 @ 1
7.2 Differing functions to KRONE ISOBUS terminal CCI
Via the accessory unit, the ISO control unit will provide information and control functions to the
display of the ISO terminal. Operation with an ISO terminal is analogue to the KRONE ISOBUS
terminal CCI. Prior to start-up, refer to the operating instructions for the method of operation of
the KRONE ISOBUS terminal CCI.
A fundamental difference to the KRONE ISOBUS terminal CCI is the arrangement of the
softkeys, which are determined by the selected ISO terminal.
Only the functions that differ from the KRONE ISOBUS terminal CCI are described in the
following.
Pos: 26.8 /BA/Inf o-Center/Iso-Bedi enung/BigPack/Abweic hende Funktionen CCI_Ter minal Pressklappen @ 47\mod_1285233314609_ 78.docx @ 456042 @ @ 1
Note
The values for “Bale channel flap pressure/force”, “Bale length” and “Number of MultiBales”
which are set by the scroll wheel in the basic screen on the KRONE ISOBUS terminal CCI, are
set on the ISO terminal with the selection key predetermined by the ISO terminal (refer to the
operating instructions of the ISO terminal manufacturer).
Pos: 26.9 /BA/Inf o-Center/Iso-Bedi enung/Abweichende Funkti onen CCI_Term Menüpunkt 1- 4 „Kontrast“ @ 48\mod_1286 276672656_78.doc x @ 460458 @ 3 @ 1
Note
Menu item 1-4 "Contrast" of the KRONE control cannot be called up on the ISO terminal. A
setting is performed directly via the ISO terminal (if applicable) (refer to operating instructions of
the ISO terminal manufacturer).
If necessary, acoustic signals must be enabled from the terminal (refer to operating instructions
of the ISO terminal manufacturer).
Pos: 26.10 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ @ 1