Krone Big Pack 4x4 - Setting the bale length

KRONE ISOBUS-Terminal CCI 100
76
Pos: 22.37.22 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI -BiG Pack/Grundbild Hand betrieb/Einstel len der Ballenlänge Handb etrieb Bild HS Baureihe @ 99\ mod_1329894194876_78. docx @ 883945 @ @ 1
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11F11
F12
1/2
Fig.43
Pos: 22.37.23 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI -BiG Pack/Grundbild Hand betrieb/Einstel len der Ballenlänge Handb etrieb HS Baureihe @ 63\ mod_1299852886404_78. docx @ 576958 @ @ 1
6.4.3 Setting the bale length
Note
(BP 890;1270;1290)
The bale length can be set in the range from 100 - 270 cm (39 - 106 inches).
(BP 1290 HDP; BP 4x4)
The bale length can be set in the range from 100 - 320 cm (39 - 126 inch).
Note
Only adjust the bale length at the start of a bale, otherwise in-between lengths could arise.
Pos: 22.37.24 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI -BiG Pack/Scroll-Rad an wählen,springen,er höhen bzw. verringer n,speichern @ 43\mod_127529 5180531_78.doc x @ 390064 @ @ 1
• You can use the scroll wheel to select the desired selection (A) (the selection box is
highlighted in color)
• Pressing the scroll wheel allows you to jump to the selection box (the selection box is
highlighted in color)
• Turning the scroll wheel increases or reduces the value
• Pressing the scroll wheel causes the setting to be applied and returns you from the
selection box
Pos: 22.37.25 /BA/I nfo-Center/CCI- ISOBUS-Terminal/CCI -Rundballenpressen/ Grundbild/Hinweis Ei nstellung über Touchsc reen @ 79\mod_1315290 154790_78.doc x @ 701913 @ @ 1
Note
The values can also be set via the touchscreen.
Pos: 22.37.26 /BA/---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ @ 1