Settings
236
Pos: 34.83 /BA/Einste llungen/Großpackenpr esse/Grundein stellung der Bandbrems e (Schwungrad) @ 24\mod_12414 40070086_78.doc x @ 244924 @ 2 @ 1
11.12 Basic setting of the band brake (flywheel)
BPXC0168
1
a
Fig. 173
The band brake is positioned on the left side of the flywheel. If the braking action is no longer
adequate when the band brake is applied, it can be readjusted by lengthening the spindle (1).
Basic setting: Dimension a = 182 mm
Pos: 34.84 /BA/Einste llungen/Großpackenpr esse/Packensc hurre einstellen @ 24\m od_1241442284883_78.d ocx @ 244974 @ @ 1
11.13 Setting the bale chute
Fig. 174
When it is unfolded, the bale chute represents an extension of the bale channel chamber. For
big bales to be set down on the ground correctly, the back edge of the bale chute must not be
too high above the ground. Otherwise the bales will be damaged when they are placed on the
ground.
• The inclination of the bale chute to the ground can be sued to adjust the length of the
retaining chain (2) of the bale chute
• To do this, adjust the nut (1) on either side of the baling channel
Pos: 34.85 /BA/Einste llungen/Großpackenpr esse/Hinweis Ba llenwaage kalibrier en @ 92\mod_1326782125428 _78.docx @ 781789 @ 2 @ 1
Note
If the inclination of the bale chute is changed, the bale scale must be recalibrated if the machine
has one (see chapter on KRONE ISOBUS terminal CCI "Calibrating the Bale Scale").
Pos: 34.86 /BA/--- ------------ Seitenumbruch------ ---------- @ 0\mod_119617 5311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
