Settings
221
Note
Put “advanced”(b) in front means:
The large roller on the packer strip (4), which runs in front of the feeder strip (5), is in front
of the inspection window (6)
Put “retracted”(c) behind means:
The large roller on the packer strip (4), which runs in front of the feeder strip (5), is behind
the inspection window (6)
It is not necessary to set the packer relative to the baling ram unless the following
components have been removed:
• Packer coupling (7), packer gearbox (8), chain coupling (9)
• Transfer gearbox (10) (or removal of the drive train between transfer gearbox and main
gearbox (11))
Procedure:
• Check that packer coupling has engaged
• Move VFS system to zero position (see Settings section “Zero position”)
• Move packer strip into position (see Settings section “Moving packer strip into position”)
• Move baling ram into position (see Settings section “Moving baling ram into position”)
Pos: 34.79.17 /BA/---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.doc x @ 4165 @ 3 @ 1
To Next Page
Loading...
