EasyManua.ls Logo

Krone Big Pack 4x4 - Page 288

Krone Big Pack 4x4
332 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Malfunctions - Causes and Remedies
288
Pos: 40.8 /BA/Störungen - Ursachen und Behebung/ Großpackenpressen/ Tabellarische Auf listung Hydraulikb lock entlüften T1 @ 116\mod _1340791155161_78. docx @ 1019481 @ 2 @ 1
Malfunction Cause and/or remedy
The tractor does not start or starts just
badly if the Load Sensing line is
connected.
1
BPHS0111
Y17
Cause:
Air in the hydraulic system of the machine
Remedy:
Vent the hydraulic block comfort
Prerequisite:
• Turn off the PTO shaft
• Secure the machine and the tractor against rolling
• Apply the flywheel brake
If the tractor starts badly
To do this:
• Remove the plastic cover (1) on the valve (Y17)
• Loosen the inner threaded pin M4 with two revolutions
• Collect escaping hydraulic oil in a suitable container and dispose of it correctly
• Start the tractor engine and charge the hydraulic system with pressure
• Switch on the terminal and execute the function “remaining bale ejector” via the
terminal until the escaping oil is free of bubbles
• Tighten the threaded pin M4 when the escaping oil is free of bubbles
• Attach plastic cover on the valve (Y17)
If the tractor does not start
To do this:
• Switch on the terminal
• Execute several functions one after another (e.g. remaining bale ejector, chute)
to release the hydraulic system
• Start the engine of the tractor
• Should the tractor engine still not start yet, please contact your KRONE dealer or
KRONE customer service
• Charge the hydraulic system with pressure when the tractor engine starts
• Remove the plastic cover (1) on the valve (Y17)
• Loosen the inner threaded pin M4 with two revolutions
• Collect escaping hydraulic oil in a suitable container and dispose of it correctly
• Execute function “remaining bale ejector” via the terminal until the escaping hydraulic
oil is free of bubbles
• Screw in the threaded pin M4 when the escaping hydraulic oil is free of bubbles
• Attach plastic cover on the valve (Y17)
Pos: 40.9 /BA/--- ------------ Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ 3 @ 1

Table of Contents