Work regulations
• The instructions in the manufacturer’s documentation for the individual
components must be observed when carrying out cleaning work.
• It must be ensured that no cleaning agents enter electrical compo-
nents.
• Do not use compressed air during cleaning work.
Procedure
1. Loosen and vacuum up any dust deposits.
2. Clean the controllers with a solvent-free cleaning agent and a suitable
cloth.
3. Clean cables, plastic parts and hoses with a solvent-free cleaning
agent.
4. Only clean polycarbonate surfaces with a gentle cleaning agent.
5. Replace damaged or missing inscriptions, labels and plates.
Detailed information about the individual components is contained in
the manufacturer’s documentation.
ready2_educate
BA ready2_educate V8 | Issued: 05.09.2018 www.kuka.com | 117/154
Maintenance
To Next Page
Loading...
