3. Carefully remove the plugs from the holes of the knurled screws using
a screwdriver and put them in the PE bag.
4. Screw 4 knurled screws into the holes.
7.1.2 Transport packaging
Description
The cell must be packaged in transport packaging prior to transportation.
Procedure
1. Place the cell on a pallet using a pallet truck or a fork lift truck.
2. Fasten both unattached side panels to the cell.
3. Attach the rear panel to the cell.
4. Attach the front panel using 6 screws.
5. Fasten the cover using 4 screws.
Fig. 7-2: Transport packaging
ready2_educate
86/154 | www.kuka.com BA ready2_educate V8 | Issued: 05.09.2018
Transportation
To Next Page
Loading...
