1 Energy supply system
2 Gripper holder
3 2-jaw parallel gripper
3.4.4 Application components
Description
The gripper is used to grip the various components and set them down in
new positions.
Overview
Fig. 3-21: Application components
1 Magazine with tool holder
2 Paper holder
3 Quick-action clamp
4 Cube 25x25 mm
5 Coordinate system
6 Positioning pin
7 Wire contour PATH + SPLINE
8 Metal loop tool
9 Pen tool
10 Calibration tip
It is possible for the users to make application components themselves.
It is only necessary to ensure that these are adapted to the application
plate with its 50x50 mm hole pattern.
The user-made application components may not have a drive of their
own.
In the case of user-made application components, the user is responsi-
ble for reanalyzing the risk and hazard situation and implementing cor-
responding safeguards.
ready2_educate
BA ready2_educate V8 | Issued: 05.09.2018 www.kuka.com | 25/154
Product description
To Next Page
Loading...
