Kuka ready2 educate - Uninstalling Ready2_Educate; Installation, Ready2_Educate_Advanced; System Requirements, Ready2_Educate_Advanced

LOG file
A LOG file is created under C:\KRC\ROBOTER\LOG.
9.1.3 Uninstalling ready2_educate
It is advisable to archive all relevant data before uninstalling a software
package.
Precondition
• User group “Expert”
• T1 or T2 mode
• No program is selected.
• Network connection between PC and robot controller
If the ready2_educate_advanced and/or ready2_educate_vision op-
tion package(s) is/are additionally installed, the ready2_educate_ad-
vanced and/or ready2_educate_vision option package(s) must be un-
installed first, as they are dependent on ready2_educate
(>>> 9.2.3 "Uninstalling ready2_educate_advanced" Page 97).
Procedure
1. Load the project from the robot controller.
2. Remove the gripper configuration Gripper configuration from the
project structure.
3. Remove the ready2_educate option package from the project. A win-
dow with modifications is displayed.
4. Deploy the project from WorkVisual to the robot controller and activate
it.
5. Answer the request for confirmation Do you want to activate the
project […]? with Yes.
6. An overview with the changes and a request for confirmation are dis-
played on the smartHMI. Answer this with Yes. The option package is
uninstalled and the robot controller carries out a reboot.
Information about procedures in WorkVisual is contained in the WorkVi-
sual documentation.
LOG file
A LOG file is created under C:\KRC\ROBOTER\LOG.
9.2 Installation, ready2_educate_advanced
9.2.1 System requirements, ready2_educate_advanced
Hardware
• KR C4 compact
Software
• KUKA System Software 8.3.x
• GripperSpotTech 4.0.x
• WorkVisual 4.0.x
ready2_educate
BA ready2_educate V8 | Issued: 05.09.2018 www.kuka.com | 95/154
Installation