• Avoid wind and drafts.
• Avoid condensation.
• Avoid high air humidity.
• Use appropriate coverings that cannot detach themselves and which
can withstand the expected environmental conditions.
• Do not leave any loose parts on the components, especially ones that
might knock against other parts; either remove or fasten accordingly.
• Do not leave the components exposed to direct sunlight while in stor-
age.
• Observe and comply with the permissible temperature ranges for stor-
age.
• Select a storage location in which the packaging materials cannot be
damaged.
• In the case of longer-term storage, check the components.
15.3 Disposal
When ready2_educate reaches the end of its useful life, the individual
components must be dismantled and the materials disposed of properly by
type. Dismantling and disposal can be carried out by any suitable compa-
ny.
The following table provides an overview of the materials used. All plastic
components are marked with a material designation and must be disposed
of accordingly.
Material
Subassembly, compo-
nent
Additional information
Metals
Copper Cables, wires
Steel Screws, washers, housing,
application plate, applica-
tion components
Plastics
PUR Cable sheaths
PU Hoses, rollers
PC Windows
PA Cubes
Wood
Transport box
Information about disposing of the robot and robot controller can be
found in the operating or assembly instructions of the robot and in the
operating or assembly instructions of the robot controller.
ready2_educate
BA ready2_educate V8 | Issued: 05.09.2018 www.kuka.com | 137/154
Decommissioning, storage and disposal
To Next Page
Loading...
