Overview
Fig. 3-41: Application components
1 Magazine with tool holder
2 Paper holder
3 Quick-action clamp
4 Cube 25x25 mm
5 Coordinate system
6 Positioning pin
7 Wire contour PATH + SPLINE
8 Metal loop tool
9 Pen tool
10 Calibration tip
It is possible for the users to make application components themselves.
It is only necessary to ensure that these are adapted to the application
plate with its 50x50 mm hole pattern.
The user-made application components may not have a drive of their
own.
In the case of user-made application components, the user is responsi-
ble for reanalyzing the risk and hazard situation and implementing cor-
responding safeguards.
3.6.5 Mounting plate, pneumatic system
Description
The service unit supplies the gripper with compressed air. The operating
pressure for the gripper can be set using the pressure regulating valve.
The shut-off valve is used for locking and unlocking the service unit.
The pneumatic system mounting plate may vary according to the
ready2_educate variant.
Setting:
• Operating pressure: 6 bar
ready2_educate
BA ready2_educate V8 | Issued: 05.09.2018 www.kuka.com | 39/154
Product description
To Next Page
Loading...
