Kurzweil PC3K Series - The EQ Page; The OUTPUT Page

6-70
Program Mode
The EQ Page
The EQ Page
Thefourcolumnheadersonthispagerepresenttwoshelvingbandsofequalizationandtwo
parametricbands.TheKB3EQofferedhere,though,isnotimplementedasatrueEQsection;
instead,itadjuststhevolumeofthetonewheelsbasedonfrequency.Ifthetonewheelsare
basedonsine
waves,thenthisactssimilarlytoarealEQ.
EachEQsectionhasGain(G),Frequency(F),andWidth(W)controls.Frequencycontrolsthe
centerfrequencyoftheband.Widthcontrolsthebandwidth.Gaincontrolstheamountofboost
orcut.
The OUTPUT Page
Usethispagetoroutethecurrentprogram’spost‐FXsignals.ThetwoPanparameters
correspondtothoseoftheVASTProgrameditorOUTPUTpage(Seepage 6‐30).TheOutGain
parametercorrespondstothatoftheVASTProgrameditorCOMMONpage(Seepage 6‐33).
Parameter Group (Available for each EQ band) Range of Values
Gain -24.0 to 24.0 dB, in 0.2-dB increments
Frequency 16 to 25088 Hz, in varying increments
Width -128 to 128 Semitones, in 2-semitone increments