Kurzweil PC3K Series - The RIFF2 Page

Setup Mode
Riffs
7-61
The RIFF2 Page
ThesecondRiffpageappearsasshownbelow,andhasthe followingparameters:
Trigger
Thereareafewwaystotriggerriffsinsetupmode.OntheRiff2pageyoucanusetheTrigger
fieldtosetakeyboardkeytotriggertheRiff.Also,anyphysicalcontrollercanbeassignedto

controllerdestination163RiffOn.
Tosetthekeyrangetotr iggeryourriff,usethecursorbuttonstoselecttheleftvalueinthe
Triggerfield(thiswillbethelowendofthetriggerkeyrange.)Nowyoucanselectthekey
numberbyscrollingtheAlphaWheel,or
youcanuseintuitiveentrybypressingandholdingthe
Enterbuttononthealphanumericpadandpressingthedesiredkeyonyourkeyboard.Youwill
seethisvaluechangeasyoupressa key.
Parameter Range of Values Default
Trigger
(HiKey) C -1 to G9 C -1
(LoKey) C -1 to G9 G9
Release
(HiKey) C -1 to G9 C -1
(LoKey) C -1 to G9 G9
CondRel Off, On Off
Local Off, On Off
Loop Once, Forever Forever
BPM Sequence, Setup, External, 20 to 400 Sequence
Sync Zone First Avail., Riff 1-16, Main Seq, Arp 1-16, FirstRiff.Av., First
Arp.Av
First Avail.
Sync Type None, DownBeat, AnyBeat, DownBeatWait, AnyBeatWait,
Loop, Stop, StartWait, LoopWait, StopWait
None
Release Sync Zone (RelSynZn) First Avail., Riff 1-16, Main Seq, Arp 1-16, FirstRiff.Av., First
Arp.Av
First Avail.
Release Sync Type (RelSynTyp) None, DownBeat, AnyBeat, DownBeatWait, AnyBeatWait,
Loop, Stop, StartWait, LoopWait, StopWait
None
Duration 1 to 1000% 100%
Velocity 0 to 255% 100%
Offset -32768 to 32767 0