Kurzweil PC3K Series - The Footswitch Pages (FT SW1, FT SW2, FT SW3)

Setup Mode
The Footswitch Pages (FT SW1, FT SW2, FT SW3)
7-37
The Footswitch Pages (FT SW1, FT SW2, FT SW3)
Onthebackoftheinstrument,therearethreejacksforFootswitchpedals.
Allthefootswitchesinthedefaultcontrolsetuparesettoaswitchtypethatdoesn’tgeneratea
note,andconsequentlytherangeofvaluesfortheirrespectiveDestinationparametersisthe
ControlDestinationlist.Thereare
threeFootswitchpages,oneforeachFootswitch.
TheFTSWpageparametersaredescribedinSwitchControllerParameters on page 7‐31.
Parameter Range of Values Default
Type Momentary, Toggle Momentary
On Control Control Destination List
Ft Sw1: Sustain
Ft Sw2: Sostenut
Ft Sw3: Soft
On Value None, 0 to 127 127
Off Control Control Destination List
Ft Sw1: Sustain
Ft Sw2: Sostenut
Ft Sw3: Soft
Off Value None, 0 to 127 0
Entry State None, Off, On None
Exit State None, Off, On None