Kurzweil PC3K Series - The Setup Editor

Setup Mode
The Setup Editor
7-5
Table 7‐2givesyouaquickvisualreminderofhowzonesbehavedependingontheirstatus.
RememberthatanychangesyoumaketozonestatusinSetupmodearetemporary;assoonas
youselectanothersetup,thatsetup’sprogrammedzonestatustakesover.Tochangeasetup’s
zonestatuspermanently,
usetheSetupEditor(seeStatus on page 7‐8).
Soloing a Zone
Tosoloazone,settheStatusparameterontheSetupEditorCH/PROGpage(seeTheSet upEditor
andTheChannel/Program(CH/PROG)Pagebelow)toSolo(orSolo+Muted).TheChan/Layer
buttons—inadditiontoscrollingthroughthezonesofthecurrentsetup—nowselectthesoloed
zone.Ifyouscrollthroughthe
zones,youwillseetheredsoloLEDmovingacrossthemute
buttons.Afteronezoneissoloed,youcanchooseadifferentzonetobesoloedbypressingonits
zone‐statusbutton;thisactionunsolosthepreviouslysoloedzone.
Additionally,youcanconfigureasetupsuchthatyoucan
solozonesinrealtimebyassigning
anyofthecontrollerdestinationstoSoloZn.SeeControllers on page 7‐20formoreinformation
oncontrollerdestinationassignmentsinSetupmode.
The Setup Editor
FromSetupmode,presstheEditbuttontoentertheSetupEditor,whereyoucanmakechanges
tothecurrentlyselectedsetup.UsethesoftbuttonstoselectthevariousSetupEditorpages.The
upperlineofeachpagedisplaystheusualmodereminder,aswellasthecurrentSetupEditor

page,andthecurrentzone.UsetheChan/Layerbuttonstoselectoneofuptosixteendifferent
zones,eachhavingitsownsetofSetupEditorpages.
TheparametersontheSetupEditorpagesdefinewhateachofasetup’szonessends—bothto
internalprogramsandtotheMIDIOutport.
TheyalsodeterminehowthePC3K respondsto
MIDIsignalsreceivedfromaMIDIcontrollerconnectedtothePC3K’sMIDIInport(whenthe
LocalKeyboardChannelmatchesthetransmitchannelofyourMIDIcontroller).
Compare
PressingtheStoragebuttoncallsuptheCompareEditor,whichrecallsthesetuppre‐edit
settings,allowingyoutocompareyoureditedsetupwiththeoriginalsetup.Pressingthe
StoragebuttonagainreturnsyoutotheSetupeditor.UsingtheCompareEditormakesno
changestothecurrentsetup.
Thedisplaydiagramsyouseeinthischaptershowthedefaultvaluesforsetup126Internal
Voice s.
LED Color
Zone
Status
Data Generated by Zone
Notes Controllers
Program
Number
Entry and
Exit Values
Red
Solo,
Solo+Muted
Yes Yes Yes Yes
Green (no others are red) Active
Yes Yes Yes Yes
Green (another is red) Backgrounded No No
Yes Yes
Orange Muted No No
Yes Yes
(Off) Empty No No No No
Table 7-2 Zone Status in Setup Mode