Kurzweil PC3K Series - Common DSP Control Parameters

6-14
Program Mode
Algorithm Basics
sourceintheControllerListtomodulatethefunction‐parameter.Theaboveitalicized
parameter‐typesaredescribedinCommonDSPControlParameters on page 6‐14.More
informationonthesubpagescanbefoundinTheDSPControl(DSPCTL)Page on page 6‐28and 
TheDSPModulation(DSPMOD)Page on page 6‐29.
Highlightinganyofthefunction
‐blocksontheALGpageandpressingtheEditbuttontakesyou
totheDSPCTLpage.
Common DSP Control Parameters
ThetypeofDSPfunctionavailableforanyfunctionblockdependsonthealgorithm.Someofthe
specializedfunctionslikethePANNERarealwayslocatedjustbeforethefinalAMPfunction.
Others,likethethree‐inputfunctions,appearonlyinalgorithmsthatarestructuredfor three‐
inputfunctions.
Youcanchange
thenatureofeachlayerofaprogramsimplybyassigningdifferentDSP
functionstothelayer’salgorithm.Yourlevelofcontrolgoesmuchdeeperthanthat,however.
EachDSPfunctionhasoneormoreparameterstowhichyoucanpatchavarietyofcontrol
sourcestomodifythebehaviorof
theDSPfunctionsthemselves.
Theparametersonthevariouscontrol‐inputpagesareverysimilar;infact,therearesix
parametersthatappearonalmosteverypage.Consequentlywerefertothemasthecommon
DSPcontrolparameters.Althoughtheparametersonthecontrol‐inputpagesdifferslightly
fromfunctionto
function,youcanexpecttosee someorallofthecommonDSPcontrol
parameterswheneveryouselectthecontrol‐inputpageforanyoftheDSPfunctions.
You’llrecognizethecommonDSPcontrolparameters,alongwithseveralotherparameters.
Keepinmindthatthere’sasetofcommoncontrolparameters
foreachoftheDSPfunctions;in
thiscasewe’redescribingthemonlyastheyapplytothepitchcontrolfunction.
Function-parameter
UnliketheotherfivecommonDSPparameters,thefunction‐parametersareaccessibleonboth
theDSPCTLpageandtheDSPMODpage.Theyarelistedalongtheleft‐handside
ofeachpage;
anychangesmadetothemononepagearereflectedintheother.Thelabelofeachfunction‐
parameterdependsonitsfunctioninthecurrentprogram’salgorithm.Forexample,thePitch
function’sfunction‐parameterislabeledPitch;whereasthetwo‐blockLopassfunction’s
function‐parametersare
labeledLPFrqandLPRes.