Kurzweil PC3K Series - The DSP Modulation (DSPMOD) Page

Program Mode
The DSP Modulation (DSPMOD) Page
6-29
Thelabelofafunction‐parameterdependsonitscorrespondingfunction‐blockinthecurrent
layer’salgorithm.TheaboveDSPCTLpagecorrespondstothefollowingalgorithm:
The DSP Modulation (DSPMOD) Page
Beforereadingfurther,besuretoreadAlgorithmBasics on page 6‐13andCommonDSPControl
Parameters on page 6‐14.
PresstheDSPMODsoftbuttontocalluptheDSPModulation(DSPMOD)page,whichis
displayedbelow:
Eachfieldintheleft‐handcolumnofthepageisafunction‐parameterofthecurrentlayer’s

algorithm.Youcancoarselyadjustthefunction‐parameterintheseleft‐handfields—asnotedin
CommonDSPControlParameters,anyadjustmentsmadetothefunction‐parametersonthe
DSPMODpagearereflectedinthecorrespondingfunction‐parametersontheDSPCTLpage.
Theright‐handsideoftheDSPCTLpageis
thesubpageofthehighlightedfunction‐parameter—
onthesubpagearetheprogrammableparameters.Toaccesstheparametersonthesubpage,
highlightthefunction‐parameteryouwishtoedit,andthenpressthe>buttontomovethe
cursorintothesubpage.
Parameter Range of Values Default
Source 1 Control Source List Off
Depth (Depends on Function) 0
Source 2 Control Source List Off
Depth Control Control Source List Off
Minimum Depth (Depends on Function) 0
Maximum Depth (Depends on Function) 0