Work out investigational procedures and scope of systems and components concerned with the
help of DTC or trouble symptom table based on DTC data or symptoms.
5. Electrical check
Locate and figure out further causes of trouble in this way.
6. Repair
Repair damaged systems and components.
7. Validation test
Make sure if the fault is eliminated under identical environment or conditions.
8. Maintenance record
Record and file off for treatment.
VI. Fuse check and replacement
A type (blade) Fig. 4-13
Fig. 4-13
B type blade Fig. 4-14
Fig. 4-14
C type blade Fig. 4-15
Fig. 4-15
To Next Page
Loading...
