Fig. 2-69
Install silencer pad on each brake pad. ②
The wear indicator is upwards. Install the inside brake pad, and then the outside.③
Note: The friction surface between the brake pad and the brake disc should be free of engine oil
or grease.
10) Install the rear disc brake slave cylinder.
Install the rear disc brake slave cylinder by 2 bolts. ① See Fig. 2-70. Tightening torque: 34N·m.
Fig. 2-70
Install the new washer and hose by joint bolt. ② Tightening torque: 30N·m. Note: Secure the hose
tightly in the locking hole of the brake slave cylinder.
11) Fill brake fluid into the reservoir.
12) Discharge the air in the brake slave cylinder.
13) Discharge the air in the brake pipeline.
14) Check the brake fluid level in reservoir.
15) Check if there is brake fluid leakage.
16) Install the rear wheel. Tightening torque: 103N·m.
v. Inspection of parking brake system
Parking system as shown in Fig. 2-71
Fig. 2-71
1. Parking brake control lever assembly
To Next Page
Loading...