As shown in Fig. 4-41.
Fig. 4-41
Note 1: When the key is inserted into ignition lock, it’s useless to press the locking key
and
unlocking key
of remote controller.
3. Alarm setting
Alarm setting condition: Ignition switch connected, ignition key pulled out, four doors and luggage
boot closed.
(1) Alarm setting by remote locking control
1) When alarm setting condition is met, press the locking key on remote controller (prompt
operation), locking of four doors will act simultaneously, the steering light flashes for once and
annunciator sounds for once; burglar indicator flashes, together with system fuel cut-off, and brake
to indicate state of alert;
2) If the alarm setting condition with four doors and luggage boot closed is not qualified, the
steering light flashes for ten seconds to indicate door close; after ten seconds, the burglar indicator
flashes, together with system fuel cut-off and brake to indicate state of alert.
(2) Alarm setting by two-time remote unlocking control
① When alarm setting condition is met, press the unlocking key on remote controller, unlocking of
four doors will act simultaneously, the steering light flashes for twice and annunciator sounds for
twice, burglar indicator goes out, and fuel supply recovers.
If any of the doors is not opened within 30 seconds, the four doors lock, burglar indicator ②
flashes, together with fuel cut-off and brake to indicate state of alert.
(3) Logical flow of alarm setting
To Next Page
Loading...