Section V Scrapping Tips for Air Bag Module
When scrapping the air bag module, remove the air bag module first. If scrapping the vehicle
equipped with air bag system, or the air bag module, the air bag module should always be
deployed as the following operation procedure. If something abnormal appears in the process of
deployment, contact the service center of Lifan Passenger Car Co., Ltd. When lacking in the
conditions of scrapping, please deliver the module to related departments for disposal.
1. When deploying the air bag, loud noise will be heard. Therefore, the air bag should be deployed
in an outside open area with no nuisance to others.
2. When deploying the air bag, the operation shall be carried out by the professionals.
3. After the air bag is deployed, the air bag module will become very hot. Thus, do not touch it until
at least 30min later after the deployment.
4. When handling the deployed air bag module, put on gloves and safety glasses. After finishing
the operation, wash hands cleanly.
5. Forbid to water the deployed air bag module.
6. After the deployment of air bag module, the gas generator will be with a high temperature, and
should be handled after being cooled for more than 30min.
7. Put on gloves and safety glasses to remove the deployed air bag module.
8. Put the air bag into a plastic bag, fasten the mouth of the bag, and then dispose as scrap. See
Fig. 5-12.
Fig. 5-12
9. After operation, do not forget to wash hands.
Note: Environmental protection treatment for the scrapped air bag module is needed.
To Next Page
Loading...
