(5) TRITEC 1. 6 engine controller pin (see Table 1-2)
Table 1-2
S/N Mark Name Resistance value Tolerance
J1-01 V-IGK Ignition switch 11.9K ±0.1%
J1-02 V-EL Main relay output 1.8K ±0.1%
J1-03 VS Vehicle speed sensor ∞
J1-04 TMAP-VCC
Pressure/temperature sensor
power supply
189.2K ±10K
J1-05 TPS-GND Throttle position negaive 0.6 0.2Ω
J1-06 VSL-U-1B
Front oxygen sensor
grounding end
∞
J1-07
J1-08
J1-09 ACCIN A/C compressor switch input 9.9K ±0.1K
J1-10 CAM Camshaft input positive 5.0K ±0.1K
J1-11 K-LINE Diagnostic line 143.2K ±1K
J1-12 CRK
Crankshaft sensor input
negative
55.2K ±1K
J1-13
J1-14 CANL CAN low ∞
J1-15 CANH CAN high 18M ±2M
J1-16
J1-17 VBAT Battery voltage positive ∞
J1-18 VBAT Battery voltage positive ∞
J1-19
J1-20 TPSVCC Throttle position positive ∞
J1-21 TMPGND Temperature/pressure low 0Ω ±0. 5Ω
J1-22 Exhaust MIL 65.5M ±1M
J1-23 AD4 AD4 1.8M ±0.2M
J1-24 TPS Throttle position sensor signal ∞
J1-25
J1-26
EVAP Evaporated liquor temperature
sensor signal
6.2K ±0.1K
J1-27 TIA Intake air temperature signal 3.3K ±0.2K
J1-28 CRKGND Crankshaft sensor low 55.5K ±0.5K
J1-29
J1-30
J1-31 MIL Malfunction indicator light 56.7K ±0.7K
J1-32 IGC Ignition coil 1,4 1.3M ±0.5M
J1-33 STPBH Stepper motor B+ 20.3K ±O.2K
J1-34 STPBL Stepper motor B- 20.5K ±0.1K
To Next Page
