10. Check the door lamp alarm buzzer
Check the working condition: Ignition switch at ON (IG1) position, if one of the four doors is
unclosed, it will buzz, till one condition is eliminated, buzz stops.
11. Check the brake warning lamp
(1) Check the parking brake warning lamp: Disconnect the parking brake switch
Connect the connector terminal at the side of parking brake switch wire and the body with harness
connector, ignition switch ON-position, check the parking brake warning lamp, normally lit;
(2) Check the brake fluid level warning lamp: Disconnect the connector of brake fluid level warning
lamp, short-connect the connector terminal at the side of parking brake switch wire, ignition switch
ON-position, check the brake fluid level warning lamp, normally lit.
12. Check the brake fluid level warning switch: Remove the fluid reservoir lid and the cleaner,
disconnect the harness connector of brake fluid level warning switch, and check the conductivity
between the terminals of brake fluid level warning switch, normally not conducted while floater is
rising. Suck out the brake fluid in reservoir, and check the conductivity between the terminals of
brake fluid level warning switch, normally conducted while the floater is descending.
To Next Page
Loading...