DTC Table 5-1 (Continued)
DTC Description
Lifan
DTC
Bosch
DTC in
EEPROM
Driver Belt Pretensioner Short to Battery tbd 8067
Passenger Belt Pretensioner Resistance High tbd 8058
Passenger Belt Pretensioner Resistance Low tbd 8057
Passenger Belt Pretensioner Short to GND or Cross Coupling tbd 8059
Passenger Belt Pretensioner Short to Battery tbd 8060
Battery Voltage High tbd 9328
Battery Voltage Low tbd 9327
Driver Buckle Switch Circuit Fault tbd 8097
System Warning Lamp Short to GND or Open tbd 8671
System Warning Lamp Short to Battery tbd 8673
Driver Buckle Switch Warning Lamp Circuit Fault tbd 8595
III. Fault checking and repairing (as shown in Table 5-2)
Table 5-2
S/N
Possible
Faults
Areas Fault Clearing Methods
1
Ground wire
deficient
Earth wire
Harness
1. Preparation before checking; 2. Check the earth wire, if normal,
go to the step 3; if loose or disconnected, repair it; 3. Check the
harness, if normal, the parts with faults have been recovered; if not,
repair or renew the harness.
2
Voltage too
high
Battery
1. Preparation before checking; 2. Check the battery voltage, if
normal, the parts with faults have been recovered; if too low, charge
or renew the battery.
3
DAB
inexistence
Driver air bag
module
Clock spring
Harness
Air bag ECU
1. Preparation before checking; 2. Check the driver air bag circuit, if
normal, go to the step 3; if not, go to 5; 3. Check the air bag ECU, if
normal, go to 4; if not, renew the air bag ECU; 4. Check the driver
air bag module, if normal, the parts with faults have been recovered;
if not, renew the driver air bag module; 5. Check the clock spring, if
normal, go to 6; if not, renew the clock spring; 6. Check the harness
between the air bag ECU and clock spring, if normal, the parts with
faults have been recovered; if not, repair or renew the harness.
To Next Page
Loading...
