III. Structure of the front passenger seat assembly:
1. The assembly structure as shown in Fig. 7-8.
Fig. 7-8
Note:
The process of installation and that of removal are reverse. Therefore, only the extra steps of the
installation will be referred.
1. Removal
(1) Remove the front passenger seat lower guard panel
a. Remove one bolt
b. Remove the left front foot cap of the front passenger seat.
(2) Remove the left rear foot cap of the front passenger seat.
(3) Remove the two bolts of the front passenger seat front slide rail.
(4) Remove the rear two bolts of the front passenger seat and the whole assembly.
Torque: 20.4N·m
2. Installation
Installing as per the reverse order, and pay attention to the following points:
Fix the bolt at the torque of 20.4N·m
To Next Page
Loading...
