primer manufacturer.
Don’t touch the bo② dy and old adhesive surfaces to adhere and connect with the glass.
(3) Install the new strip on the glass. For convenience, heat the strip at the temperature of 35 ℃
one and a half hours.
(4) Clean the glass surface to adhere and connect to the body with the clean cloth. If the cleaning
agent has been used, dry at least 10 minutes.
(5) Coat the glass surface to adhere and connect to the body with the enough primer at the
thickness of 15mm with new brushes.
Note:
The correct operation and drying time shall be practiced as per the Instruction Manual of the ①
manufacturer.
Don’t touch the ② primer coating surface.
(6) Attach the windshield tent on the front windshield and coat it the adhesive.
Note:
Start from the hemline of the glass.①
Don’t ruin the ② primer.
After coating, press the glass on the body as soon as possible.③
After coating, use the ④ rubber adhesive disc to install and convey the glass.
Complete th⑤ e step 6 and 7 within 10 minutes to guarantee the agglutinate strength.
The correct operation and drying time shall be practiced as per the Instruction Manual of the ⑥
manufacturer.
Don’t touch the body to agglutinate with the glass and the old adhesive⑦ surface.
(7) Hold the rubber adhesive disc, press the glass on the body and clap the glass surface and
surrounding areas of the strip so as to glue the glass on the body completely.
Note: Don’t damage the glass surface or body.
(8) Install the coping side sealing strip.
(9) After the solidifying of the adhesive, check whether the window leaks or not through splashing
water in the hose on it. If the window leaks, dry the glass and fill the leaking position with the
adhesive. After filling, if it keeps leaking, remove the glass and reinstall as per above steps.
Note:
Don’t use the high① -pressure water.
② When drying, don’t let the adhesive coating parts expose directly to the compressed air. Don’t
use the infrared ray bulb and the similar stuffs to dry.
③ Before the adhesive complete solidifying, the sudden closing the car door may result in glass
looseness or falling off. Therefore, before the adhesive part completely adheres to the door, open
or close the door in a correct way.
If the strip④ does not completely glue, press it with the adhesive tape until all the adhesive parts
installed closely.
Every adhesive has its own solidifying time. ⑤ Do not forget to refer to the Instruction Manual of
the manufacturer, check the solidifying time of the adhesive used and observe the necessary
measures taken before the complete adherence of the adhesive parts.
Before complete adherence of the adhesive parts, forbid to drive so as to guarantee the ⑥
complete and full solidifying.
(10) Install the windshield wiper.
To Next Page
Loading...
