After coating, use the ④ rubber adhesive disc to install and convey the glass.
Complete the step 6 and 7 within 10 minutes to guarantee the agglutinate strength. ⑤
The corre⑥ ct operation and drying time shall be practiced as per the Instruction Manual of the
manufacturer.
(7) Hold the rubber adhesive disc, press the glass on the body and clap the glass surface and
surrounding areas of the strip so as to glue the glass on the body completely.
Note: Don’t damage the glass surface or body.
(8) Install the coping side sealing strip.
(9) After the solidifying of the adhesive, check whether the window leaks or not through splashing
water in the hose on it. If the window leaks, dry the glass and fill the leaking position with the
adhesive. After filling, if it keeps leaking, remove the glass and reinstall as per above steps.
Note:
Don’t use the high① -pressure water.
When drying, don’t let the adhesive coating parts expose directly② to the compressed air. Don’t
use the infrared ray bulb and the similar stuffs to dry.
Before the adhesive complete solidifying, the sudden closin③ g the car door may result in glass
looseness or falling off. Therefore, before the adhesive part completely adheres to the door, open
or close the door in a correct way. The correct operation and drying time must conform to the
Instrument Manual of the manufacturer. Don’t touch the surface of the primer coating surface.
If the strip④ does not completely glue, press it with the adhesive tape until all the adhesive parts
installed closely.
Every adhesive has its own solidifying time. ⑤ Do not forget to refer to the Instruction Manual of
the manufacturer, check the solidifying time of the adhesive used and observe the necessary
measures taken before the complete adherence of the adhesive parts.
Before complete adherence of the adhesive parts, forbid to drive so as to guarantee the ⑥
complete and full solidifying.
(10) Install all the interfaces connecting to the rear windshield.
To Next Page
Loading...
