Page 3 of 182 TP1A002–1 English
Aug 2015
Linx 8900 Operating Manual —
Installation
Linx 8900
Before you turn on the printer, make sure that the information shown on the label on the
rear panel matches your power source. The mains cable has a socket on one end, which
connects to the printer. A local plug is fitted to the other end of the cable.
Make sure that the switch of the local mains electrical supply socket is isolated before you
connect the printer to the power supply.
One of two types of cable is supplied. The cables have the same specification but the colours
of the wires are different. The wire colours in the cable are as follows.
WARNING: THIS PRINTER MUST BE EARTHED/GROUNDED.
WARNING: THE PRINTER MUST BE ELECTRICALLY WIRED ONLY BY A QUALIFIED AND
COMPETENT ELECTRICIAN. LINX CANNOT ACCEPT RESPONSIBILITY FOR ANY INJURY TO
PERSONNEL OR DAMAGE TO MACHINERY CAUSED BY INCORRECT OR FAULTY WIRING.
Wire colour Connection
Green-Yellow Green Earth/Ground
Blue White Neutral
Brown Black Live
Table 1-1. Wire colours
To Next Page
Loading...
Need help?
General