Gocator Line Profile Sensors: User Manual
Getting Started • 48
Next Steps
After you complete the steps in this section, the Gocator measurement system is ready to be configured
for an application using the software interface. The interface is explained in the following sections:
Management and Maintenance (page 81)
Contains settings for sensor system layout, network, motion and alignment, handling jobs, and sensor
maintenance.
Scan Setup and Alignment (page 103)
Contains settings for scan mode, trigger source, detailed sensor configuration, and performing
alignment.
Models (page 159)
Contains settings for creating part matching models and sections.
Measurement (page 180)
Contains built-in measurement tools and their settings.
Output (page 318)
Contains settings for configuring output protocols used to communicate measurements to external
devices.
Dashboard (page 330)
Provides monitoring of measurement statistics and sensor health.
Toolbar (page 70)
Controls sensor operation, manages jobs, and replays recorded measurement data.
To Next Page
Loading...
Need help?
General
