LORAD AFFINITY Series - Removing Covers and Panels From the Gantry

P/N 9-500-0255 6-3
Service Manual
Chapter 6: Maintenance—Remove and Replace Procedures
Gantry Components—Remove and Replace
2.1 Removing Covers and Panels From the Gantry
The maintenance instructions in this chapter will require cover or panel removal to gain
access to the interior of the unit. Refer to this section for all Gantry cover removal
procedures. Be sure to turn the unit OFF and remove the power cord (if applicable) before
removing the covers.
Legend for Figure 6-2
1. Right-side Cover
2. Left-side Cover
3. Upper Rear Panel
4. Rear Connector Panel (with Shroud installed)
5. Lower Rear Panel/Power Distribution Assembly
Figure 6-2: Gantry Components—Covers and Panels
STOP