P/N 9-500-0255 3-11
Service Manual
Chapter 3: Functional Checks/Setting Defaults
The Affinity Series Control Panel
Calibration Screen #1 (Figure 3-11)
allows changes to system calibration
values such as Filament Current
Calibration Screen #2 (Figure 3-12) is
accessed when setting up and cali-
brating the automatic exposure con-
trol system, including the AEC Gain,
AEC Offset, and AEC Density. When
Cal Screen #2 is selected, the
machine is fixed in Auto-Time Mode.
Figure 3-11: Calibration Screen #1—
Calibration Mode
Figure 3-12: Calibration Screen #2—
Calibration Mode
To Next Page
Loading...