Issue 9 October 1998
2-1
Lucent Technologies
2
Equipment and Rear Access Cable
Installation
Overview
This section provides the information for rear access installation and covers the
installation information for the shelf, heat baffles, fans, rear access cables, and
grounding.
This installation manual contains the latest cable information at the time of issue.
For up-to-date information, refer to the ED cable drawings listed in the "About This
Document" section. For miscellaneous equipment information, refer to
"Miscellaneous Equipment" in the section "Introduction".
Description
This section should be performed on all rear access shelf installations. For front
access installations, refer to the "Equipment and Front Access Cable Installation"
section of this manual. In Releases 11 and 13, certain cables, associated with
specific circuit packs, require front installation between packs and, therefore, their
installation is discussed in the section on circuit pack installation.
Observe the following notes:
NOTE
:
This section requires previous bay frame installation and grounding. The
shelf should be grounded by its mounting screws.
To Next Page
Loading...
Need help?
General
