EasyManuals Logo

Lucent Technologies DDM-2000 OC-3 Installation Manual

Lucent Technologies DDM-2000 OC-3
492 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #255 background imageLoading...
Page #255 background image
363-206-204
Release 6 Installation Tests
Issue 9 October 1998
5-7
â– 
Backspace and Underbar (_) — Erases the previous character input.
â– 
At-sign (@) — Erases the current line.
â– 
CANcel, and DELete — Terminates the current input line or currently run-
ning command.
â– 
Hyphen (-) — Separates identifiers in the command mode.
â– 
Colon (:) — Separates parameter blocks in a command.
â– 
Comma (,) — Separates parameters within a parameter block in a com-
mand.
Login Procedure
1. Connect one of the approved terminals (properly configured) to an
EIA-232D port on one of the DDM-2000 OC-3s in the bay.
NOTE
:
If properly cabled, connection to any EIA-232D in the bay will allow com-
munication to any shelf in the bay.
2. Enter a ?
to prompt the DDM-2000 OC-3 to request a shelf address.
The DDM-2000 OC-3 will respond:
/* Enter a shelf number from 1 to 8 */
shelf [default] =
NOTE
:
The default shelf is the one physically connected to the CIT. If you press
"Ënter" without entering a shelf number, the default shelf will be selected.
3. After entering a valid shelf number the user is presented with:
login<
NOTE
:
There is a special login and password already programmed into the system
for use during the execution of these tests. The login is LUC01 and the
password is DDM-2000. For circuit packs and shelves manufactured up to,
but not including, 1 October 1996, the login is ATT01. Both login and
password must be UPPERCASE.
NOTE
:
The login and password
must
be uppercase.
After a successful login, the DDM-2000 OC-3 will display the system
header followed by the alarm and status report:

Table of Contents

Other manuals for Lucent Technologies DDM-2000 OC-3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies DDM-2000 OC-3 and is the answer not in the manual?

Lucent Technologies DDM-2000 OC-3 Specifications

General IconGeneral
BrandLucent Technologies
ModelDDM-2000 OC-3
CategoryMultiplexer
LanguageEnglish

Related product manuals